Loading documents preview...
ACS800 multidrive
6- and 12- pulse operation +
UC
W1
V1
U1
Unet
_
UD1
Unet
1.
2.
3.
4.
6.
W1
V1
U1
5.
UD
UD2
60o
360 o
1. +
UC _
2.
3.
5.
6.
W1
V1
U1
U D1
4.
60o
U1 = U 0 o
Unet
1.
UD1
UD2 30o
UC
Copyright © ABB Oy
4.
5.
6.
W2
1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12 V1 V2
U1 U2
360o
ACS800 - 1, rev. 1
3. V2
U2
U D2 U2 = U 30o
2.
W1 W2
ACS800 multidrive
Diode supply system board
Diode supply system board The (parallel) DSU modules (1-5 pcs) are controlled by the common DSSB (Diode supply system board).
Actual value display
The amount of DSU modules (S1) and the limit of the earth fault current (S2) are defined with the dipswitches of the DSSB board .
Displayed actual value
Supply power, currents or voltages can be indicated with seven segment actual value display of the board. The value is indicated with the yellow LEDs on the board. The displayed variable can be changed by display selection buttons.
Supply status leds
Supply unit faults are indicated with red LEDs.
Supply dip- switches S2
ACS800 - 2, rev. 1
Copyright © ABB Oy
S1
ACS800 multidrive
Dip switch settings
Dip settings (earth fault current) Switch S1 PIN 1(1A) PIN 2 (2A) PIN 3 (4A) PIN 4 (8A) PIN 5 (16A) Switched off OFF OFF OFF OFF OFF 1A ON OFF OFF OFF OFF 2A OFF ON OFF OFF OFF 3A ON ON OFF OFF OFF 4A OFF OFF ON OFF OFF 5A ON OFF ON OFF OFF (Default) 6A OFF ON ON OFF OFF 7A ON ON ON OFF OFF 8A OFF OFF OFF ON OFF …. 31A ON ON ON ON ON Dip settings (amount of modules) Switch S2 PIN 1 PIN 2 1 module OFF OFF 2 modules ON OFF 3 modules OFF ON 4 modules OFF OFF 5 modules OFF OFF
ACS800 - 3, rev. 1
PIN 3 OFF OFF OFF ON OFF
Copyright © ABB Oy
PIN 4 OFF OFF OFF OFF ON
PIN 6