Etap Knowledge Base: Motor Starting Curve

ETAP Knowledge Base

Motor Starting Curve Description: Required data to view a motor starting curve in a STAR View Category:

STAR

Type:

Information

Keywords:

STAR, Motor Starting Curve

To view a motor starting curve in a STAR View, the following data is required a) Nameplate of the motor (see the Nameplate page of the motor editor) b) Locked rotor current (LRC) in percent of FLA (see Model page of the motor editor) c) Full load acceleration time (see Protection page of the motor editor) When all of these values have been specified and a starting curve is checked in the Protection page, the motor starting curve will be seen in the STAR View. NOTE: If the motor starting curve is not visible, check the Alert View

for any missing data.

This document is confidential and proprietary to Operation Technology, Inc. and may not be reproduced, published or disclosed to others without the written authorization of Operation Technology, Inc., 17 Goodyear, Suite 100, Irvine, CA 92618, USA. © 2010 by Operation Technology, Inc. All Rights Reserved.

© Operation Technology, Inc.

Page 1 of 2

ETAPKB

ETAP Knowledge Base

Motor Starting Curve

This document is confidential and proprietary to Operation Technology, Inc. and may not be reproduced, published or disclosed to others without the written authorization of Operation Technology, Inc., 17 Goodyear, Suite 100, Irvine, CA 92618, USA. © 2010 by Operation Technology, Inc. All Rights Reserved.

© Operation Technology, Inc.

Page 2 of 2

ETAPKB