Etap Knowledge Base: Track Pickup

ETAP Knowledge Base

Track Pickup Description: When do you use "Track Pickup" Category:

STAR

Type:

Modeling

Keywords:

Track PickUp

The trip device manufacturer reference curves shall indicate if the time band settings track the current pickup or not. Typically this information is available on TCC curve horizontal axis (i.e [x In], or [x Ir], …) Some manufacturer would indicate on datasheet as well. The following show two examples and hope it helps.

This document is confidential and proprietary to Operation Technology, Inc. and may not be reproduced, published or disclosed to others without the written authorization of Operation Technology, Inc., 17 Goodyear, Suite 100, Irvine, CA 92618, USA. © 2010 by Operation Technology, Inc. All Rights Reserved.

© Operation Technology, Inc.

Page 1 of 2

ETAPKB

ETAP Knowledge Base

Track Pickup

This document is confidential and proprietary to Operation Technology, Inc. and may not be reproduced, published or disclosed to others without the written authorization of Operation Technology, Inc., 17 Goodyear, Suite 100, Irvine, CA 92618, USA. © 2010 by Operation Technology, Inc. All Rights Reserved.

© Operation Technology, Inc.

Page 2 of 2

ETAPKB