Calibration Of Pressure Gauge

7.0 DISCUSSION i) What happen if there is air trapped in the cylinder? Ii)What is the purpose of using water fot the dead weight pressure tester? Iii)What will happen if other liquid is use to replace the water? CONCLUSION AND RECOMMENDATION The objective to determine the accuracy in Bourdon gauge readings andcalibration requirements is achieved.

REFERENCES 1. N. E. Connor, Gas Quality Measuring Devices on Gas Measurement University of Salford, 1969 2. DH- Budenberg, An-Introduction-to-Dead-WeightTesters @ http://www.vbook.pub.com/doc/18933664 (25th Nov, 2009) 3. Wikipedia Encyclopaedia (www.wikipedia.com) 4. Practical Manual on pressure gauge calibration, 2009.