Jlokp Mpa Bolt

MPA Bolt System™ MPA Bolt System™ * Fast, single-step anchoring system using standard equipment. Efficient installation since drilling and grouting can be performed in a single operation, saving both time and money. • 32 mm, Self-Drilling, Hollow-Core Bolt • Threaded both ends (39 in. & 24 in.) • 39” yield zone with up to 20% elongation • Multiple ranges of drill bits available for most rock & soil conditions • 60,000 lbf capacity • Corrosion protection systems available upon request The MPA Bolt System is specially designed for use with J-LOK P™ Pumpable resin, eliminating the capsule and injecting directly into the hollow-core bolt.

Pumbable J-LOK P™ * • Uses a specialized pump and J-LOK™ formulation • Injects J-LOK into the hollow-core bolt • Designed for hard rock mines with the end goal of reaching a 100% automated process • Specialized pump attached to bolter or stand-alone pump

ble J-LOK (J-LOK P)

• Completely automated injection process from cab

The smooth de-bond zone allows for up to 6 inches of elongation and can be covered with PVC for added corrosion protection.

• Can be adapted for rebar or cable bolts

d to bolter * The MPA Bolt System jection process from cab and Pumpable J-LOK P System (including resin) are both the subject of pending U.S. or cable boltspatent applications issued to FCI Holdings Delaware, Inc.

J-LOK P skid-mounted pump. Pump components can also be attached directly to bolter (at left).

www.jennmar.com Section 7: Specialty Bolts

(412) 963-9071 •

Page 88

J-LOK P™ Pumpable Resin

Pumpable J-LOK (J-LOK P)

Pumbable J-LOK P

™*

• Uses a specialized pump and J-LOK™ formulation

Two Methods:

• Injects J-LOK into the drill hole to anchor the bolts • Designed for hard rock A. mines with the end goal Pre-Injection of reaching a 100% automated 1. Injectprocess J-LokP into drillhole.

A

• Specialized pump attached to bolter 2. Insert bolt & spin to mix.

B

• Completely automated injection process from cab • Can be adapted for rebar or cable bolts B. Post-Injecting Two Methods • A - P  re-Injection

1. Install bolt w/ grout tube. 2. J-LokP mixes in grout tube to anchor bolt.

–– Inject J-LOK P into drillhole –– Insert bolt and spin to mix • B - Post-Injection

Pumpable J-LOK (J-LOK P)

–– Install bolt with grout tube

–– J-LOK P mixes in grout tube to anchor bolt

Component system can be skid-mounted or bolter-mounted. 5/26/2016 3

Pumpable J-LOK (J-LOK P)

The J-LOK P Pumpable Resin System can operate as a skid-mounted unit (left) or the components can be mounted directly to a bolter (right).

• attached Specialized ialized pump to bolter pump attached to bolter pletely automated injection process from cab • Completely automated injection process be adapted for rebar or cable bolts

from cab

• Can be adapted for rebar or cable bolts

* The Pumpable J-LOK P System (including resin) is the subject of pending U.S. patent applications issued to FCI Holdings Delaware, Inc.

www.jennmar.com Section 9: Resins & Cement Cartridges

(412) 963-9071 •

Page 108