Etap Knowledge Base: User Curve Label

ETAP Knowledge Base User Curve Label

Description: User Curve does not show the label Category:

User Curve

Type:

Modeling

Keywords:

Label

User Curve does not show the label: Answer: In fact the label for that particular User Curve is available but since the point [0] has Y=0.0001, the label goes down very bellow the TCC. A- Change the Y value for point [0] from 0.0001 to 0.02 to see the label. B- Or change the order for point [0] & [1] to see the label. (enter point [1] first) C- Alternatively, if you want to show the vertical line as a fault arrow, I would suggest entering the ampere value as kA in “Fault_kA” field, as indicate bellow:

This document is confidential and proprietary to Operation Technology, Inc. and may not be reproduced, published or disclosed to others without the written authorization of Operation Technology, Inc., 17 Goodyear, Suite 100, Irvine, CA 92618, USA. © 2010 by Operation Technology, Inc. All Rights Reserved.

© Operation Technology, Inc.

Page 1 of 1

ETAPKB